Ruijie RG-WLAN Series User Manual

Configuration Guide Configuring 802.1X
Command
dot1x valid-ip-acct timeout time
Parameter
Description
time: Indicates the timeout in the unit of minutes.
Defaults
The default value is 5 minutes.
Command
Mode
Global configuration mode
Usage Guide
It is recommended to use the default value. Configure this command when there is a need to change the IP
address obtaining timeout after users pass authentication.
 Configuring the Bypass WLAN for the RADIUS Server
 Optional.
 Enable bypass WLAN for the RADIUS server after 802.1X authentication is enabled on the NAS.
Command
dot1x event server-invalid action bypass-wlan wlan_id
Parameter
Description
wlan_id: Indicates the bypass WLAN.
Defaults
Bypass WLAN is disabled by default.
Command
Mode
Global configuration mode
Usage Guide
This command applies only to wireless devices.
It is recommended to use the default value. Configure this command when there is a need to provide the
corresponding WLAN in the case of server inaccessibility.
 Configuring 802.1X Authentication for Encryption Only When802.1X and Web Authentication Are Both Enabled
 (Optional) If 802.1X and Web authentication is enabled meanwhile, 802.1X is used only for encryption.
 Enable this function after 802.1X authentication is enabled on the NAS.
Command
dot1x encryption only
Parameter
Description
N/A
Defaults
This function is disabled by default.
Command
Mode
WLAN security configuration mode
Usage Guide
It is recommended to retain the default setting.
This command applies only to wireless devices.
 Limiting the Rate of Printing Online and Offline Logs
 (Optional) You can limit the syslog printing rate upon 802.1X users going online/offline.
 Enable the syslog printing rate limit after 802.1X authentication is enabled on the NAS.
Command
dot1x logging rate-limit value

Ruijie RG-WLAN Series Specifications

General

Brand	Ruijie
Model	RG-WLAN Series
Category	Wireless Access Point
Language	English