Configuration Guide Configuring SCC
default offline-detect: Restores the default value. In other words, an online user will be disconnected when
the device detects that the user does not have any traffic within eight hours.
Global configuration mode
Use this command to configure user online-status detection, so that a user is disconnected when its traffic is
lower than a specific threshold within a specific period of time. Use the no offline-detect command to
disable the user online-status detection function, or use the default offline-detect command to restore the
default detection mode.
Verification
Check the user online-status detection configuration using the following method:
After the user online-status detection function is enabled, power off the specified authenticated terminal after the
corresponding user gets online. Then wait for the specified period of time, and run the online user query command
associated with dot1x or Web authentication on the device to confirm that the user is already offline.
Configuration Examples
The following configuration example describes SCC-related configuration only.
Configuring User Online-Status Detection so that a User Is Disconnected if the User Does Not Have Traffic Within
Five Minutes
Network
Environment
Figure 12-2
Enable dot1x authentication on the access port Gi 0/2, and configure authentication parameters. The
authentication is MAC-based.
To Next Page
Loading...
