21
Counting with Additional Requirements
How to Change the Reference Sample Quantity:
You can change the reference sample quantity as required.
The reference sample quantity is displayed above the unit symbol after you press
.
To select the change function: Hold down
for more than 2 seconds
To change the setting: Use identified by - ^-
lf you enter a wrong number, press
to clear it
To store the ref. qty.: — temporarily until you turn off the power:
briefly press
— permanently after you turn off the power:
press
for more than 2 seconds
This setting is not cancelecl by the reset code 9--1° !
How to change the reference sample quantity Code
No change
in cycless: 5, 10, 20, 50, 100, 5, 10, ...
in increments of one
*
2
2
2
3
3
3
1
2
3
Storage Parameter for the Reference Sample Weight
The weight is stored Code
with full accuracy according to internal resolution
according to the display accuracy
*
3
3
5
5
1
2
Reference Sample Updating
While counting (piece count readout), you can press
identified by - OPT- to Update the reference sample for optimizing the
accuracy. In the process, the reference weight is recalculated based on the total reference sample weight and the piece count
displayed.
It makes sense to use the reference sample updating function when the weight of a reference sample quantity is lighter than 100
digits. In this case, you should approximately double the reference sample quantity. You can repeat reference sample updating
several times, using double the quantity for each updating Operation.
Use in Combination with Other Programs
The counting program can be used in combination with other application programs.
This means you have all functions of the combined program additionally available.
Program Code
Tare memory
Over/under checkweighing (net weight)
Over/under checkweighing difference in weight)
2
2
2
2
2
2
2
3
4
* = Factory setting
To Next Page
Loading...
Need help?
General