23
Brief Instructions for Setting Menu Code
Turn your balance off and then back on again.
While all segments are displayed, briefly press the tare control.
lf "-
L
-" is displayed, change to the "-
C
- " mode using the menu access switch.
Select the desired code number as follows:
— press
to increase it or
—
to decrease it.
Select the left, middle or right place as follows:
— press the
key to go toward the left
— press the
key to go toward the right
Confirm your code selection by pressing the control labeled
Adjust the menu access switch back to the original setting-readout: “ –
L
“
To leave the menu, press
To Next Page
Loading...
