Sartorius mc1 - Page 104

25
Over/Under Tolerance Limits Automatic Output of Parameters
Code Changes Code Changes
+/- 0,1 % dev. 4 1 1 Off 7 1 1 *
+/- 0,2 % dev. 4 1 2 Ref. %/qty. + ref wt 7 1 2
+/- 0,5 % dev. 4 1 3 Ref. wt. only 7 1 3
+/- 1,0 % dev. 4 1 4 *
+/- 1,5 % dev. 4 1 5 Data ID Code
+/- 2,0 % dev. 4 1 6 Code Changes
+/- 2,5 % dev. 4 1 7 Off 7 2 1 *
+/- 3,0 % dev. 4 1 8 On 7 2 2
+/- 5,0 % dev. 4 1 9
+/- 10,0 % dev. 4 1 10 Automatic tare Output/Printing
Code Changes
Auto. Output of Acceptable Values Indiv. tare wt. 7 3 1 *
Code Changes Tare wt. total 7 3 2
On 4 2 1
Off 4 2 2 * Analog Display
Code Changes
Activation of Port Lines Off 8 5 1
Code Changes Bar graph 8 5 2 *
Only in ch. range 4 3 1 Marker 8 5 3
Always on 4 3 2 *
Only at stability within
checkweighing range 4 3 3
Only at stability 4 3 4
* = Factory setting