That’s all there is to it!
Now, if you press the
key, you can read the weight in carats "ct":
Of course, you'll be in the IQ-Mode™, with a load-dependent readability of
0.01%, as defined by the factory-set menu code.
You say you don't like it?
You'd rather weigh in the unit "ct" with the highest possible accuracy down to the
last digit?
No problem!
Just set the appropriate code:
3 2 1. (You'll find this code listed under "Display Modes" on page 16.)
How to set code 3 2 1 for full resolution in the second weighing range
- Turn off the balance
- Turn it back on
- While all segments are displayed, briefly press the tare control
- Change the left-hand number to “3”
- Move to the middle number
- Change the middle number to “2”
- Move from "2" to the right-hand number (When you move to the right-hand
number, the previously set numeric code will appear.)
- Change the right-hand number to “1”
To Next Page
Loading...
