33
Brief Instructions for Setting a Menu Code
Turn your balance off and then back on again.
While all segments are displayed, briefly press the tare control.
If “ – L “ is displayed, change to the “ – C “mode using the menu access switch.
Select the desired code number as follows:
— press
to increase it or
—
to decrease it
Select the left-hand, middle or right-hand position as follows:
— press the
key to go toward the left
— press the
key to go toward the right
Confirm your code selection by pressing the tare control
Adjust the menu access switch back to the original setting - readout:” – L «”
To leave the menu, press
.
To Next Page
Loading...
Need help?
General