SLT12 User Manual
91
Stakeout sample rounding angle
Select the stakeout center angle item, set the closing difference, starting center angle, diameter distance, angle
increment, and other parameters, and then click OK to jump to the reference arc stakeout interface, click
Save/Measurement- Store to calculate the stakeout information, and expand the graphic interface on the right to
display the current position, prism points, and the position relationship between the stakeout points.
"Misclosure ": see the parameters of the stakeout arc term.
"Start rounded comers": set to g, then the starting stakeout point is the position of the starting point in the
reference arc offset clockwise by an angle g, and 0 < g < 360.
"Offset": see the parameters of the stakeout point item.
"Angle increment": set to f, then the stakeout interface can switch the stakeout point in steps of Angle increment
f by the up point down point button, and 0<f<360.
Figure 8- 42
Figure 8- 43
To Next Page
Loading...
