SLT12 User Manual
53
7.1
Measure (Coordinate Measurement)
See Chapter 5 Basic Measurement - Coordinate Measurement.
7.2 Dist. Offset
If the point to be measured (P) is known to deviate from the Offset point (T0) in the observation direction of the
front and rear, left and right Offset, then the coordinates of the T0 point can be measured by the Distance Offset
function. You can enter the Distance Offset interface through [Collection] - [Dist. Offset]. The operation steps
are as follows.
1. Enter the Offset distance as shown in the figure below and click "OK".
Figure 7- 1
2. Aim at the target point and click "Measure" to get the distance between the station and the target point.
Figure 7- 2
To Next Page
Loading...
