SLT12 User Manual
55
being measured.
Figure 7- 5
3. Aim at Measured point P0, Then the instrument calculates and displays the coordinates of the point of
intersection of the alignment axis and the plane - the coordinates of point P0.
Figure 7- 6
[Store]: Store the Offset points obtained by calculation to the point library.
[Next plane]: You can recalculate the next point from step 1.
7.4
Column Offset
This function is used to determine the circular center point position of cylindrical objects, such as the
determination of large trees, oil tanks, etc. The Cylindrical Offset interface can be accessed through [Collection]
- [Column Offset]. The operation steps are as follows.
To Next Page
Loading...
