SLT12 User Manual
173
Figure 14- 12
14.3.2 Pt Name Increment
Each time a measurement point is saved, the point number is self-incremented, and this configuration is used to
set the step of point number self-increment.
14.3.3 Note
When you open this item, you can save the measurement point during coordinate measurement, and save the
photo of the point at the same time. And you can view it in the measurement point library.
14.3.4 Rename tips
Open this item and it cannot save the rename point.
14.4
Unit & Display
Users can click [Configuration] - [Unit & Display] to enter this interface.
Figure 14- 13
To Next Page
Loading...
