SLT12 User Manual
62
Figure 7- 19
3. Aim at the target point T, and the software calculates the value of REM in real-time.
Figure 7- 20
[Prev.]: Return to the previous step, you can view the previous measurement information.
[Finish]: Restart the REM
7.7
Line & Extension Point
When the point to be measured is on the line of two measurable points and the distance from the point to be
measured to the last measurement point is known, the [Line&Extend Point] (two distance Offset) function can be
used for calculation. Enter the measurement interface through [Collection] - [Line&extend point]. The operation
steps are as follows.
To Next Page
Loading...
