SLT12 User Manual
50
Figure 6- 22
2. Enter the measurement interface of straight line - end point B. Enter the target height according to the
instruction, click "Meas." for the end point of the reference line, and then click "Next".
Figure 6- 23
3. Enter the point-to-line set station interface. Continue to align the end point of the reference line (as the
Backsight point), enter the point name, Ground code, and instrument height of the station, and click "OK" to
complete the point-to-line station setting. The local relative coordinate system of the reference line established
by the station is with point A as the coordinate origin (0,0,0), point B as the coordinate north direction, and the
coordinates of point B relative to point A are (Hd, 0, Vd).
To Next Page
Loading...
