SATO E series User Manual

Section 5: Two-Dimensional Symbols
SATO Programming Reference Page 5-13
Special Notes 1. Contact SATO Technical Support for specific usage information.
2. Parameters “c”, “d”, “ee”, “f f” and “gg” are not used for Micro QR
Code.
3. Parameter “xx...x” is limited to 0001 to 0486 bytes for Model 1 and
Micro QR Code.
4. The data command should be used according to the input mode or
data type.
5. In Automatic Mode, the data for 80
H to 9FH or E0H to FFH will be
interpreted as Kanji, not binary data.
6. In Manual Mode, The multiple data fields for numeric, alphanumeric,
Kanji and binary can be specified in a job. In this case, the data fields
for <ESC>2D30 and each data field must follow the data field. Also,
the maximum data size should be less than 7000 bytes and the maxi-
mum block number for the data field is 200.
7. If the parameters are not correctly specified, the symbol will not be
printed.

SATO E series Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Max. Print Speed	6 ips (inches per second)
Max. Print Width	4.09 inches (104 mm)
Interfaces	USB, Ethernet
Media Type	Labels, Tags, Ticket
Ribbon Length	Up to 984 ft (300 m)
Power Supply	AC 100-240V, 50/60 Hz
Print Resolution	203 dpi