Appendix A: Command Code Quick Reference
SATO Programming Reference Page A-9
INSTRUCTION DESCRIPTION PAGE
aaaa = Horizontal length in dots of area to be reversed.
bbbb = Vertical height in dots of area to be reversed.
& Store Form Overlay. Stores a specified label image in the printer’s
volatile form overlay memory.
2-35
/ Recall Form Overlay. Recalls the label image from the printer’s
formoverlay memory for printing.
2-34
0 (zero) Replace Data (Partial Edit). Provides the ability to replace a specified
area of the previous label with new data.
2-58
*a Clear Print Job(s) and Memory. Clears individual memory and
buffers.
2-19
a = When not included in command, clears print jobs in
Multi-Buffer mode.
a = If included in command, specifies memory section to
be cleared
T Custom character memory, printer
& Form overlay memory, printer
X Clears all memory all memory and buffers
@,nnnn Off-Line. Signals the printer to go off-line after the completion of a print
job.
2-48
nnnn = Optional message to be displayed on the LCD panel.
Maximum of 32 characters.
~aaaa Cut Job. Cuts labels at a specified interval in a print job. Number of
labels printed is equal to the product of the Quantity specified times the
value of aaaa.
2-24
aaaa = Number of labels between each cut (0001 to 9999)
~Aaaaa Cut. Specifies the number of labels to print between each cut. It is
independent of the Quantity command.
2-23
aaaa = Number of labels between each cut
~B Cut Last. Cuts any printed labels that remain in the printer 2-25
Instruction Description Page
To Next Page
Loading...
Need help?
General
