SATO S84 ex - Page 130

4 Operation and Configuration
128
S84-ex/S86-ex Operator Manual
Sensor Level Adjustments
The flowchart shows the sequence of the setting screens for the sensor level adjustments. The table
describes each setting screen in detail.
button
button
button
Select SENSOR LEVEL
+ button
button
Select AUTO
+ button
Select RETRY
+ button
* Press the , , or button to select an item or set the value
accordingly. The active arrow icons are shown on the screen.
* Pressing the button on each screen will revert to the SERVICE
MODE setting screen.
button
button
button
Select MANUAL
+ button
button
button
button
button
button
button
button
button
button
When I-MARK is selected When GAP is selected
Calibration succeed. Calibration failed.
button
button
Select EXIT
CALIBRATION
+ button