SATO S84 ex - Page 162

4 Operation and Configuration
160
S84-ex/S86-ex Operator Manual
EXTERNAL SIGNAL
Set the output signal type of the print end signal (PREND).
The following options are available:
Note
• Shows only if the external signal (EXT) function is enabled.
• Refer to the Timing Chart of the EXT Input Signal for details.
EXTERNAL REPRINT
Set the reprint function by reprint signal (PRIN2) from the external signal.
• ENABLE: Enable the reprint when no print quantity is remaining.
• DISABLE: Disable the reprint.
Note
The product will not reprint if a command error occurs.
CONTINUOUS PRINT
Set the reprint function by the print start signal (PRIN) from an external
signal.
• ENABLE: Enable the continuous print when no print quantity is
remaining.
• DISABLE: Disable the continuous print.
Type Operation Details
TYPE1 The print end signal (PREND) is High before label
printing, and it becomes Low after print completion. The
signal level becomes High after 20 ms.
TYPE2 The print end signal (PREND) is Low before label
printing, and it becomes High after print completion. The
signal level becomes Low after 20 ms.
TYPE3 The print end signal (PREND) is High before label
printing, becomes Low from the start to the end of print,
and becomes High again after print completion.
TYPE4 The print end signal (PREND) is Low before label
printing, becomes High from the start to the end of print,
and becomes Low again after print completion.