SATO S84 ex - Page 254

5 Emulation Mode
252
S84-ex/S86-ex Operator Manual
CTRL CODE TYPE
Set the control code type.
The options are as follows:
• STANDARD
• ALTERNATE 1
• ALTERNATE 2
• CUSTOM
STANDARD, ALTERNATE 1, and ALTERNATE 2 have control codes
preset. User can set the value for control codes if CUSTOM is selected.
USER CODE SOH
Set the SOH code.
The setting range is from 00 to FF (hexadecimal).
Three beeps will sound, indicating error, if the value is identical with other
codes (STX, CR, CNTBY).
Note
Shows only if CTRL CODE TYPE is set to CUSTOM.
USER CODE STX
Set the STX code.
The setting range is from 00 to FF (hexadecimal).
Three beeps will sound, indicating error, if the value is identical with other
codes (SOH, CR, CNTBY).
Note
Shows only if CTRL CODE TYPE is set to CUSTOM.
USER CODE CR
Set the CR code.
The setting range is from 00 to FF (hexadecimal).
Three beeps will sound, indicating error, if the value is identical with other
codes (SOH, STX, CNTBY).
Note
Shows only if CTRL CODE TYPE is set to CUSTOM.