SATO S84 ex - Page 255

5 Emulation Mode
253
S84-ex/S86-ex Operator Manual
USER CODE CNTBY
Set the CNTBY code.
The setting range is from 00 to FF (hexadecimal).
Three beeps will sound, indicating error, if the value is identical with other
codes (SOH, STX, CR).
Note
Shows only if CTRL CODE TYPE is set to CUSTOM.
LABEL ROTATION
Set the page orientation of label printing.
• 0: Print the media as usual without rotation.
• 90: Print the media with 90 degree rotation.
• 180: Print the media with 180 degree rotation.
• 270: Print the media with 270 degree rotation.
SOP EMULATION
Set the types of Start of Print (SOP) emulation.
The options are as follows:
• AUTO: Auto selection based on the value set in <STX>O command.
• DISABLED: <STX>O command is ignored.
• PROD+ 110: Offset will be set by minus 110.
• ALLEG 220: Offset will be set by minus 220.
• PROD 250: Offset will be set by minus 250.
COMPATIBILITY TTF
Set whether to allow the use of TrueType font compatible mode.
• ENABLE: Allow the use of TrueType fonts.
• DISABLE: Do not allow the use of TrueType fonts.
By enabling the TrueType font compatible mode, the bold TrueType font
will be printed in smaller pitch.
/$%(/527$7,21
'(*