9 Appendix
392
S84-ex/S86-ex Operator Manual
Power ON
Backfeed Backfeed
Print 1st label Print 2nd label
Head check
Label feed
External signal
PREND(TYPE1)
Operation
PRIN
PREND(TYPE2)
PREND(TYPE3)
PREND(TYPE4)
Home position
(3 pin)
Waiting time until product recognizes PRIN signal
*1
*1 Maintain PRIN signal until PREND signal is output.
Dispenser input
(9 pin)
When backfeed is complete, Home position goes Low
until the Print Start is initiated and then it goes back High.
After Dispenser input becomes High, backfeed starts
When the label is removed from the dispense area,
the Dispenser Input is initiated by the applicator.
*When the product is set to Dispenser Input Mode
it should backfeed upon recieving Print Start
no matter the Dispense Input has been triggered or not.
*1
Input Waveform
PRIN (Dispenser)
Item
To Next Page
Loading...
