SATO S84 ex - Page 395

9 Appendix
393
S84-ex/S86-ex Operator Manual
Supplementary explanation
• Keep the print start signal (PRIN) to “Low” until print end signal (PREND) is output. Refer to the below
Maintaining the Print Start Signal (PRIN) timing chart.
• Keep the output reprint signal (PRIN2) for more than 10 ms. When signal is output for shorter than
10 ms, and reprint signal is not acknowledged, the product does not perform reprinting.
Maintaining the Print Start Signal (PRIN)
Input Waveform
Item
Print Start
Printed 1 piece
Print Start
Reprint
Print End
Print
(PRIN)
(PRIN2)
(PREND)
TYPE1, TYPE2
TYPE1
TYPE2
TYPE3, TYPE4
Print Start
Reprint
Print End
Print
(PRIN)
(PRIN2)
(PREND)
TYPE3
TYPE4
Printed 1 piece
There is no problem to make the PRIN signal to High
during the dotted line with TYPE3 and TYPE4.