SATO S84 ex - Replacing the Head Open Sensor

4 Operation and Configuration
88
S84-ex/S86-ex Operator Manual
NTP IPv6 ADDRESS
Set the IPv6 address for NTP server.
The setting range is from 0000:0000:0000:0000:0000:0000:0000:0000 to
FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF.
Note
Shows only if LAN interface is selected and the SNTP function is enabled.
TIME ZONE
Set the time zone.
The setting range is from -12:45 to +14:45.
Note
Shows only if LAN interface is selected and the SNTP function is enabled.
ERROR NOTICE
Set whether or not to notify the SNTP function error.
• ENABLE: Shows an error notice when failing to correct the time.
• DISABLE: Does not show an error notice when failing to correct the
time.
Note
Shows only if LAN interface is selected and the SNTP function is enabled.
SNMP FUNCTION
Set the SNMP function.
• ENABLE: Enables the SNMP function and goes to “SNMP setting
select” screen.
• DISABLE: Disables the SNMP function and goes to “Interface select
screen.
Note
Shows only if LAN or wireless LAN interface is selected.