SATO S84 ex - Replacing the Media Sensor Assembly Open Sensor

4 Operation and Configuration
89
S84-ex/S86-ex Operator Manual
SNMP SET SELECT
Select SNMP settings.
• SNMP SETTING: Set the SNMP settings. When selected, it goes to
“SNMP setting” screen.
• SNMP TRAP SET: Select the trap number of SNMP. When selected, it
goes to “SNMP trap setting” screen.
Note
Shows only if LAN interface is selected and the SNMP function is enabled.
SNMP SETTING
Select community and authentication of SNMP.
• SNMPv1/v2c [1]: Goes to “Community name” screen.
• SNMPv1/v2c [2]: Goes to “Community 2 name” screen.
• SNMPv3 [1]: Goes to “Authentication 1 user name” screen.
• SNMPv3 [2]: Goes to “Authentication 2 user name” screen.
SNMP TRAP SET
Select the trap number of SNMP from 1 to 3.
• TRAP [1]
• TRAP [2]
• TRAP [3]
TRAP TYPE SELECT
Select SNMP trap type.
•SNMPv1
•SNMPv2c
•SNMPv3
Note
The setting will be effective after you power on the product again.