SATO S84 ex - Replacing the Top Cover Sensor

4 Operation and Configuration
90
S84-ex/S86-ex Operator Manual
COMMUNITY NAME
Input SNMP community name.
• When SNMPv1/v2c [1] is selected the default is “public”.
• When SNMPv1/v2c [2] is selected the default is “ ” (none).
Note
• Up to 32 alphanumeric characters and symbols (from 20H to 7EH) can
be set.
• Specify “ ” to input a space.
• The setting will be effective after you power on the product again.
COMMUNITY WRITE
Enable or disable writing to MIB when accessing to community.
• ENABLE: Allows writing to MIB.
• DISABLE: Does not allow writing to MIB.
Note
Writing possible OID are sysContact, sysName, and sysLocation.
USER NAME
Input SNMP authentication user name.
Press the
/ buttons to shift the cursor and press the / buttons to
change the value.
Press the ENTER button to save the value and proceed to the next
setting screen.
Note
• Up to 32 alphanumeric characters and symbols (from 20H to 7EH) can
be set.
• Specify “ ” to input a space.
• The setting will be effective after you power on the product again.
&20081,7<1$0(
SXEOLF