Manual – MOVIDRIVE® MDX61B Safety Module Option MOVISAFE® DCS..B
11
2
General information
Safety Notes
2 Safety Notes
The following basic safety notes must be read carefully to prevent injury to persons and
damage to property. The operator must ensure that the basic safety information is read
and adhered to. Make sure that persons responsible for the plant and its operation, as
well as persons who work independently on the unit, have read through the operating
instructions carefully and understood them. If you are unclear about any of the informa-
tion in this documentation, or if you require further information, please contact SEW-
EURODRIVE.
2.1 General information
Never install or start up damaged products. Submit a complaint to the shipping company
immediately in the event of damage.
During operation, drive inverters can have live, bare and movable or rotating parts as
well as hot surfaces, depending on their degree of protection.
Removing covers without authorization, improper use as well as incorrect installation or
operation may result in severe injuries to persons or damage to property.
Refer to the documentation for additional information.
2.2 Target group
Only qualified personnel are authorized to install, startup or service the units or correct
unit faults (observe IEC 60364 or CENELEC HD 384 or DIN VDE 0100 and IEC 60664
or DIN VDE 0110 as well as national accident prevention guidelines).
Qualified personnel in the context of these basic safety notes are all persons familiar
with installation, assembly, startup, programming, parameterization and operation of the
product who possess the necessary qualifications. In addition to that, they must be fa-
miliar with the relevant safety regulations and laws, especially with the requirements of
EN ISO 13849-1 and all other standards, directives and laws specified in this documen-
tation. The above mentioned persons must have the authorization expressly issued by
the company to operate, program, configure, label and ground units, systems and cir-
cuits in accordance with the standards of safety technology.
All persons involved in any other work, such as transportation, storage, operation and
disposal, must be trained appropriately.
To Next Page
Loading...