Manual – MOVIDRIVE® MDX61B Safety Module Option MOVISAFE® DCS..B
13
2
Electrical connection
Safety Notes
The following applications are prohibited unless explicitly permitted:
• Use in potentially explosive atmospheres.
• Use in areas exposed to harmful oils, acids, gases, vapors, dust, radiation, etc.
• Use in non-stationary applications.
2.6 Electrical connection
Observe the applicable national accident prevention guidelines when working on live
MOVISAFE
®
DCS..B options (e.g. BGV A3).
Perform electrical installation according to the pertinent regulations (e.g. cable cross
sections, fusing, protective conductor connection). For any additional information, refer
to the applicable documentation.
You find notes on EMC compliant installation, such as shielding, grounding, arrange-
ment of filters and routing of lines, in the documentation of the safety module. The man-
ufacturer of the system or machine is responsible for maintaining the limits established
by EMC legislation.
Preventive measures and protection devices must correspond to the regulations in force
(e.g. EN 60204-1).
2.7 Operation
Systems into which MOVIDRIVE
®
MDX61 with MOVISAFE
®
DCS..B option is installed
must be equipped with additional monitoring and protection devices, if necessary,
according to the applicable safety regulations; e.g. the law governing technical equip-
ment, accident prevention regulations, etc.
Keep all covers and doors closed during operation.
The fact that the status LED and other display elements are no longer illuminated does
not indicate that the unit has been disconnected from the supply system and no longer
carries any voltage.
Mechanical blocking or internal safety functions of the unit can cause a motor standstill.
Eliminating the cause of the problem or performing a reset may result in the drive re-
starting automatically. If this is not permitted for the driven machine for safety reasons,
disconnect the unit from the supply system before correcting the error.
2.8 Definitions
• The designation DCS..B is used as a generic term for all derivatives of the
MOVISAFE
®
product series. If a particular design variant is referred to in the manual,
then the complete designation is used.
• The term "safe" used in this manual refers to the classification as a safe function
according to EN ISO 13849-1.
• PROFIsafe is a technology standard for a safe fieldbus system.
• The "MOVISAFE
®
Assist" software is a parameterization interface for the
MOVISAFE
®
DCS21B/22B option.
• The "MOVISAFE
®
Config" software is a programming interface for the MOVISAFE
®
DCS31B/32B option.
To Next Page
Loading...