SEW-Eurodrive MOVISAFE DCS21B

132
Manual – MOVIDRIVE® MDX61B Safety Module Option MOVISAFE® DCS..B
11
Declaration of comformity for MOVIDRIVE
®
B with DCS..B option
Declaration of Conformity
11 Declaration of Conformity
11.1 Declaration of comformity for MOVIDRIVE
®
B with DCS..B option
8200521611
EC Declaration of Conformity
Bruchsal
Johann Soder
Place Date Managing Director Technology a) b)
a) Authorized representative for issuing this declaration on behalf of the manufacturer
b) Authorized representative for compiling the technical documents
901920013
28.03.13
SEW-EURODRIVE GmbH & Co KG
Ernst-Blickle-Straße 42, D-76646 Bruchsal
declares under sole responsibility that the
frequency inverters of the series MOVIDRIVE
®
B
with built-in DCS21B 28200977 / DCS22B
18247369
DCS31B 28200985 / DCS32B
18247377
are in conformity with
Machinery Directive 2006/42/EC 1)
Low Voltage Directive 2006/95/EC
EMC Directive 2004/108/EC 4)
Applied harmonized standards EN ISO 13849-1:2008 +
AC:2009
5)
EN 62061:2005
5)
EN 50178:1997
EN 60204-1:2006 + A1:2009 +
AC:2010
EN 13850:2008
EN 55011:2007
EN 61800-3:2005
EN 61800-5-1:2008
EN 61800-5-2:2007
EN 61000-6-2:2005
Other applicable standards: IEC 61508-1:2010 (part 1 to 7)
1) The products are intended for installation in machines. Startup is prohibited until it has been
established that the machinery into which these products are to be incorporated complies with the
provisions of the aforementioned Machinery Directive.
4) According to the EMC Directive, the listed products are not independently operable products. EMC
assessment is only possible after these products have been integrated in an overall system. The
assessment was verified for a typical system constellation, but not for the individual product.
5) All safety-relevant requirements of the product-specific documentation (operating instructions,
manual, etc.) must be met over the entire product life cycle.
Freely programmable safety controller for monitoring drive systems, suitable for SIL 3 IEC 61508:2010 and
PL e according to EN ISO 13849-1:2008. An EC type examination was carried out for the safety module by
the following testing institute: TÜV Rheinland Industrie Service GmbH, Alboinstr. 56, 12103 Berlin. ID of
Notified Body NB 0035