SEW-Eurodrive MOVISAFE DCS21B

74
Manual – MOVIDRIVE® MDX61B Safety Module Option MOVISAFE® DCS..B
6
Parameter descriptions of parameter group P55x in MOVIDRIVE
®
B
Startup
6.2 Parameter descriptions of parameter group P55x in MOVIDRIVE
®
B
The parameter group P55x DCS safety module in MOVIDRIVE
®
B includes display and
setting values that are specific to the DCS..B option. The factory setting is underlined
.
6.2.1 P550 DCS safety module status
Display value that cannot be changed.
Parameter P550 shows the current status of the DCS..B option.
• No DCS: No DCS..B option detected.
• RUN: Normal operation.
• STOP: Operation of option DCS..B was stopped via programming interface.
• ALARM: The DCS..B option has issued an alarm.
• ERROR: The DCS..B option has issued an error.
You have the following options to read the corresponding error or alarm message
from the error memory of the DCS..B option:
Via the XT service interface of MOVIDRIVE
®
B:
– With the DBG60B keypad
– With the MOVITOOLS
®
MotionStudio engineering software
Via the X87 service interface of the DCS..B option with the MOVISAFE
®
Assist/Con-
fig software interface.
6.2.2 P551 Digital inputs DCS DI1 – DI8
Display value that cannot be changed.
Parameter P551 shows the current status of the digital inputs of option DCS..B in the
order DI1 – DI8.
6.2.3 P552 Digital outputs DCS DO0_P – DO2_M
Display value that cannot be changed.
Parameter P552 shows the current status of the digital outputs of option DCS..B in the
following order:
• DO0_P
• DO0_M
• DO1_P
• DO1_M
• DO2_P
• DO2_M
00
I