SEW-Eurodrive MOVISAFE DCS21B

36
Manual – MOVIDRIVE® MDX61B Safety Module Option MOVISAFE® DCS..B
5
Installing the MOVISAFE
®
DCS..B option
Installation
5.4.1 Before you start
Observe the following notes before installing or removing an option:
• Before installing the option, remove the keypad (see MOVIDRIVE
®
MDX60B/61B
operating instructions, chapter "Removing/ installing the keypad") and the front cover
(see MOVIDRIVE
®
MDX60B/61B operating instructions, chapter "Removing/install-
ing the front cover").
• After having installed the option, remove the front cover (see MOVIDRIVE
®
MDX60B/61B operating instructions, chapter "Removing/ installing the front cover")
and the keypad (see MOVIDRIVE
®
MDX60B/61B operating instructions, chapter
"Removing/installing the keypad").
• Keep the option in its original packaging until immediately before you are ready to
install it.
• Hold the option card by its edges only. Do not touch any of the components.
NOTICE
Electrostatic charge.
Damage to electronic components.
• Disconnect the inverter from the power. Disconnect the DC 24 V supply and the
supply system voltage.
• Before touching the option, take appropriate measures (discharge strap, conduc-
tive shoes, etc.) to protect it from electrostatic charge.