Main Configurations
23
Step by Step
In addition to speed-dial numbers, the telephones
configured for Outward-Restricted Trunk Access (with
Permission List) can only dial numbers that start with
these combinations. When any other number is dialed,
the phone answers with a busy signal.
The Permission List already contains some combina-
tions. These can be deleted if so desired.
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
or or Enter the number for the Permission List.
... Enter the phonebook entry number for the number to
be allowed access.
Enter the number that will be allowed access (up to 16
digits).
Warning: Enter the number without the external access
code.
Wait 5 seconds Wait for a confirmation tone.
Initial state for Programming Mode.
Deleting Numbers from a Permission List
Required: Programming Mode must be active (*95
31994).
Enter the code for programming.
or or Enter the number for the Permission List.
... Enter the list entry number of the number to be delet-
ed.
Wait 5 seconds If no new number is entered after 5 seconds, the
content of that entry is removed.
Initial state for Programming Mode.
2 4
4 5 6
0 1 2 5
To change an allowed number just enter its list
entry number and the new number.
2 4
4 5 6
0 1 2 5
To Next Page
Loading...
