Siemens MC55 - AT^SPIC Display PIN Counter

MC55 AT Command Set
5.3 AT^SPIC
s
m obil e
MC55_ATC_V01.05 Page 110 of 469 2/10/04
Confidential / Released
5.3 AT^SPIC Display PIN counter
Syntax
Command Description
The read command returns an identification of the currently required password, e.g. the PIN, PUK, PH-SIM PUK
etc. The
<counter> returned by the execute command refers to this password. In case there is no currently
required password (the responses to "
AT+CPIN?" and "AT+CPIN2?" both read "READY"), the read command
nevertheless identifies the password to which the execute command response refers.
The execute command returns the number of attempts still available for entering the currently required password,
e.g. the PIN, PUK, PH-SIM PUK etc. To check whether or not you need to enter a password usecommands
AT+CPIN? , Read command AT^SPIC? and AT+CPIN2?.
Test Command
AT^SPIC=?
Response(s)
OK
Read Command
AT^SPIC?
Response(s)
^SPIC: <code>
OK
Exec Command
AT^SPIC
Response(s)
^SPIC: <counter>
OK
Write Command
AT^SPIC=<facility>
Response(s)
^SPIC: <counter>
OK
PIN ASC0 ASC1 MUX1 MUX2 MUX3
! % % % % %
Reference(s)
SIEMENS