Siemens MC55 - ATV Set Result Code Format Mode; Verbose and Numeric Result Codes

MC55 AT Command Set
2.5 ATV
s
m obil e
MC55_ATC_V01.05 Page 35 of 469 2/10/04
Confidential / Released
2.5 ATV Set result code format mode
This command determines the contents of header and trailer transmitted with AT command result codes and
information responses. Possible responses are described at 2.5.1.
Syntax
Parameter Description
[0] Information response: <text><CR><LF>
Short result code format: <numeric code><CR>
1
(&F)
Information response: <CR><LF><text><CR><LF>
Long result code format: <CR><LF><verbose code><CR>
2.5.1 Verbose and numeric result codes
Exec Command
ATV[<value>]
Response(s)
If <value>=0
0
If <value>=1
OK
PIN ASC0 ASC1 MUX1 MUX2 MUX3
! % % % % %
Reference(s)
V.25ter
<value>
(num)(&W)(&V)
Verbose format Numeric format Meaning
OK 0 Command executed, no errors
CONNECT 1 Link established
RING 2 Ring detected
NO CARRIER 3 Link not established or disconnected
ERROR 4 Invalid command or command line too
long
NO DIALTONE 6 No dial tone, dialling impossible, wrong
mode
BUSY 7 Remote station busy