Siemens MC55 - AT^SSTGI SAT Get Information

MC55 AT Command Set
14.3 AT^SSTGI
s
m obil e
MC55_ATC_V01.05 Page 366 of 469 2/10/04
Confidential / Released
14.3 AT^SSTGI SAT Get Information
Regularly this command is used upon receipt of an URC "^SSTN" to request the parameters of the Proactive
Command.
Then the TA is expected to acknowledge the
AT^SSTGI response with AT^SSTR to confirm that the Proactive
Command has been executed.
AT^SSTR will also provide any user information, e.g. a selected menu item.
The Proactive Command type value specifies to which "
^SSTN" the command is related.
Syntax
Parameter Description
MC55 Remote-SAT interface states
0 RESET
1OFF
2IDLE
3PAC
4WAIT
Test Command
AT^SSTGI=?
Response(s)
^SSTGI:(list of supported <state>s), (list of supported <cmdType>s)
OK
Read Command
AT^SSTGI?
Response(s)
^SSTGI: <state>, <cmdType>
OK
Write Command
AT^SSTGI=<cmdType>
Response(s)
OK
PIN ASC0 ASC1 MUX1 MUX2 MUX3
! % % % % %
Reference(s)
SIEMENS
<state>
(num)