Siemens MC55 - ATE Enable Command Echo

MC55 AT Command Set
4.5 ATE
s
m obil e
MC55_ATC_V01.05 Page 93 of 469 2/10/04
Confidential / Released
4.5 ATE Enable command echo
Syntax
Command Description
This setting determines whether or not the TA echoes characters received from TE during command state.
Parameter Description
[0] Echo mode off
1
(&F)
Echo mode on
Note
• In case of using the command without parameter, <value> is set to 0.
Exec Command
ATE[<value>]
Response(s)
OK
PIN ASC0 ASC1 MUX1 MUX2 MUX3
! % % % % %
Reference(s)
V.25ter
<value>
(num)(&W)(&V)