Siemens MC55 - AT^SSDA Set SMS Display Availability

MC55 AT Command Set
12.23 AT^SSDA
s
m obil e
MC55_ATC_V01.05 Page 353 of 469 2/10/04
Confidential / Released
12.23 AT^SSDA Set SMS Display Availability
This command allows to notify the MC55 of its controlling application's capability to immediately display incoming
SMS on a display.
If the application is able to display incoming SMS, class 0 SMS shall be displayed immediately. However, if it
does not, class 0 SMS shall be treated as if no message class is determined (GSM 03.38[14]).
The effect of this command if
<da>=1 is to determine the behavior of parameter <mt> of AT+CNMI:
If
<da>=1 and <mt>=1 incoming class 0 SMS need to be acknowledged with AT+CNMA (see also AT+CNMI and
AT+CSMS)
If multiplex mode is enabled (
AT+CMUX) and <da>=1 with <mt>=1 is set on any logical channel, all other chan-
nels have to use
<mt>=0.
Syntax
Command Description
The read command returns ME's current capability setting.
Test Command
AT^SSDA=?
Response(s)
^SSDA:list of supported <da>s
OK
Read Command
AT^SSDA?
Response(s)
^SSDA:<da>
OK
Write Command
AT^SSDA=<da>
Response(s)
OK
PIN ASC0 ASC1 MUX1 MUX2 MUX3
! % % % % %
Reference(s)
SIEMENS