MC55 AT Command Set
12.13 AT+CSCA
s
m
obil
e
MC55_ATC_V01.05 Page 337 of 469 2/10/04
Confidential / Released
12.13 AT+CSCA SMS service centre address
Syntax
Command Description
Write command updates the SMSC address, through which mobile originated SMs are transmitted. In text mode,
setting is used by send and write commands. In PDU mode, setting is used by the same commands, but only
when the length of the SMSC address coded into
<pdu> parameter equals zero.
Notes
• In case of using no parameter after AT+CSCA= the content of <sca> will be deleted
• This command writes the service centre address to non-volatile memo
• The SMS service centre address should be entered as specified by the service provider
Test Command
AT+CSCA=?
Response(s)
OK
Read Command
AT+CSCA?
Response(s)
+CSCA: <sca>, <tosca>
OK
Write Command
AT+CSCA=<sca>[, <tosca>]
Response(s)
OK
PIN ASC0 ASC1 MUX1 MUX2 MUX3
% % % % % %
Reference(s)
GSM 07.05
To Next Page
Loading...
