Siemens MC55 - AT&W Stores Current Configuration to User Defined Profile

MC55 AT Command Set
2.3 AT&W
s
m obil e
MC55_ATC_V01.05 Page 33 of 469 2/10/04
Confidential / Released
2.3 AT&W Stores current configuration to user defined profile
Syntax
Command Description
TA stores the currently set parameters to a user defined profile in the non-volatile memory.
Parameter Description
[0] Number of profile
Notes
• The user defined profile will be restored automatically after PowerUp. Use ATZ to restore user profile and
AT&F to restore factory settings. Until the first use of AT&W, ATZ works as AT&F.
• User defined profiles in multiplex mode:
AT&W stores the current setting of each channel to the user profile, no matter on which of the three channels
the command is executed. Each channel may have an individual profile.
• A list of parameters stored to the user profile can be found in Chapter
AT Command Settings storable
with AT&W
.
Exec Command
AT&W[<value>]
Response(s)
OK
ERROR/+CME ERROR <err>
PIN ASC0 ASC1 MUX1 MUX2 MUX3
! % % % % %
Reference(s)
V.25ter
<value>
(num)