Siemens MC55 - AT+CR Service Reporting Control

MC55 AT Command Set
7.24 AT+CR
s
m obil e
MC55_ATC_V01.05 Page 176 of 469 2/10/04
Confidential / Released
7.24 AT+CR Service reporting control
Syntax
Intermediate Result Code
If enabled, an intermediate result code is transmitted at the point during connect negotiation when the TA has
determined the speed and quality of service to be used, before any error control or data compression reports are
transmitted, and before any final result code (e.g. CONNECT) appears.
+CR: <serv>
Command Description
Configures the TA whether or not to transmit an intermediate result code +CR: <serv> to TE when a call is being
set up.
Test Command
AT+CR=?
Response(s)
+CR: (list of supported<mode>s)
OK
Read Command
AT+CR?
Response(s)
+CR: <mode>
OK
Write Command
AT+CR=<mode>
Response(s)
OK
PIN ASC0 ASC1 MUX1 MUX2 MUX3
% % % % % %
Reference(s)
GSM 07.07