Siemens MC55 - AT+CPBW Write into Phonebook

MC55 AT Command Set
15.4 AT+CPBW
s
m obil e
MC55_ATC_V01.05 Page 376 of 469 2/10/04
Confidential / Released
15.4 AT+CPBW Write into Phonebook
This command serves to write onto an entry of the phonebook selected with AT+CPBS. It can be used only after
the phonebook's data has been read successfully from the SIM. Reading starts after successful SIM authentica-
tion has been performed and may take up to 30 seconds depending on the SIM used. While the read process is
in progress, an attempt to use any of the phonebook commands will result in "+CME Error: SIM busy".
Syntax
Command Description
The test command returns the location range supported by the current storage, the maximum length of <num-
ber>
field, the range of supported <type> values and the maximum length of <text> field. Note: The length
may not be available while SIM storage is selected. If storage does not offer format information, the format list
contains empty parenthesizes.
The write command fills a phonebook entry at memory location
<location> of the active storage selected with
AT+CPBS.
If
<storage>="FD" (SIM fixed dialling numbers) is selected, PIN2 authentication has to be performed prior to
any write access.
If no
<location> is given, the first free entry will be used.
If
<location> is given as the only parameter, the phonebook entry specified by <location> is deleted.
If write attempt fails "+CME ERROR" is indicated.
Test Command
AT+CPBW=?
Response(s)
+CPBW: (1-<maxloc>), <nlength>, (list of supported <type>s), <tlength>
OK
ERROR
+CME ERROR
Write Command
AT+CPBW=[<location>][, <number>[[, <type>][, <text>]]]
Response(s)
OK
ERROR
+CME ERROR
PIN ASC0 ASC1 MUX1 MUX2 MUX3
% % % % % %
Reference(s)
GSM 07.07