Siemens MC55 - AT+CGDCONT Define PDP Context

MC55 AT Command Set
10.6 AT+CGDCONT
s
m obil e
MC55_ATC_V01.05 Page 253 of 469 2/10/04
Confidential / Released
10.6 AT+CGDCONT Define PDP Context
Syntax
Command Description
The test command returns supported values as a compound value.
The read command returns the current settings for each defined PDP context.
The write command specifies the parameters for a PDP context identified by the context identifier
<cid>. The
number of contexts that may be in a defined state at the same time is given by the range returned by the test
command. A special form of the write command (
AT+CGDCONT=<cid>) causes the values for context <cid> to
become undefined.
Test Command
AT+CGDCONT=?
Response(s)
+CGDCONT: (range of supported<cid>s), <PDP_type>, , , (list of supported <d_comp>s), (list of supported
<h_comp>s)
OK
ERROR
+CME ERROR
Read Command
AT+CGDCONT?
Response(s)
+CGDCONT: <cid>, <PDP_type>, <APN>, <PDP_addr>, <d_comp>, <h_comp>
...
OK
ERROR
+CME ERROR
Write Command
AT+CGDCONT=[<cid>[, <PDP_type>[, <APN>[, <PDP_addr>]]]]
Response(s)
OK
ERROR
+CME ERROR
PIN ASC0 ASC1 MUX1 MUX2 MUX3
% % % % % %
Reference(s)
GSM 07.07