Siemens MC55 - ATS3 Write Command Line Termination Character

MC55 AT Command Set
18.2 ATS3
s
m obil e
MC55_ATC_V01.05 Page 440 of 469 2/10/04
Confidential / Released
18.2 ATS3 Write command line termination character
Syntax
Command Description
This parameter setting determines the character recognized by TA to terminate an incoming command line.
Parameter Description
command line termination character
000...13
(&F)
...127
Note
• Using other value than 13 may cause problems when entering commands.
Read Command
ATS3?
Response(s)
<n>
OK
Write Command
ATS3=<n>
Response(s)
OK
PIN ASC0 ASC1 MUX1 MUX2 MUX3
! % % % % %
Reference(s)
V.25ter
<n>
(num)(&W)(&V)