Siemens MC55 - 10 GPRS Commands; AT+CGACT PDP Context Activate or Deactivate

MC55 AT Command Set
10. GPRS Commands
s
m obil e
MC55_ATC_V01.05 Page 243 of 469 2/10/04
Confidential / Released
10. GPRS Commands
This chapter describes AT Commands that a TE (Terminal Equipment, e.g. an application running on a control-
ling PC) may use to control the MC55 acting as GPRS Mobile Termination (MT). Please use chapter "
Using
GPRS AT commands (Examples)
" as a first guidance.
10.1 AT+CGACT PDP context activate or deactivate
Syntax
Command Description
The test command is used for requesting information on the supported PDP context activation states.
The read command returns the current activation states for all the defined PDP contexts.
Test Command
AT+CGACT=?
Response(s)
+CGACT: (list of supported <state>s)
OK
Read Command
AT+CGACT?
Response(s)
+CGACT: <cid>, <state>
[+CGACT: <cid>, <state>]
...
OK
Write Command
AT+CGACT=[<state>[, <cid>[, <cid>[,... ]]]]
Response(s)
OK
ERROR
+CME ERROR
PIN ASC0 ASC1 MUX1 MUX2 MUX3
% % % % % %
Reference(s)
GSM 07.07