Siemens MC55 - ATS10 Set Disconnect Delay after Indicating the Absence of Data Carrier

MC55 AT Command Set
7.15 ATS10
s
m obil e
MC55_ATC_V01.05 Page 158 of 469 2/10/04
Confidential / Released
7.15 ATS10 Set disconnect delay after indicating the absence of data
carrier
Syntax
Command Description
This parameter setting determines the amount of time, that the TA remains connected in absence of a data car-
rier. If the data carrier is detected before disconnect, the TA remains connected.
Parameter Description
number of tenths of seconds of delay
001...2
(&F)
...255
Read Command
ATS10?
Response(s)
<n>
OK
Write Command
ATS10=<n>
Response(s)
OK
PIN ASC0 ASC1 MUX1 MUX2 MUX3
! % ! % ! !
Reference(s)
V.25ter
<n>
(num)(&W)(&V)