Siemens MC55 - AT+CSNS Single Numbering Scheme

MC55 AT Command Set
7.26 AT+CSNS
s
m obil e
MC55_ATC_V01.05 Page 180 of 469 2/10/04
Confidential / Released
7.26 AT+CSNS Single Numbering Scheme
Syntax
Command Description
The AT+CSNS command enables the ME to accept incoming calls when no bearer capability information is pro-
vided with the call, e.g. single numbering scheme calls or calls originitating from analog devices.
Parameter Description
[0]
(D)
Voice: Each call received without bearer element is assumed to be speech
2 Fax: Each call received without bearer element is assumed to be an incoming
fax.
4 Data: Each call received without bearer element is assumed to be a data call.
Please take into account that the bearer service parameters set with
AT+CBST
apply to all data calls including those received without bearer capability.
Test Command
AT+CSNS=?
Response(s)
+CSNS: (list of supported<mode>s)
OK
Read Command
AT+CSNS?
Response(s)
+CSNS: <mode>
OK
Write Command
AT+CSNS=[<mode>]
Response(s)
OK
PIN ASC0 ASC1 MUX1 MUX2 MUX3
! % % % % %
Reference(s)
GSM 07.07
<mode>
(num)