Siemens MC55 - Page 257

MC55 AT Command Set
10.8 AT+CGQMIN
s
m obil e
MC55_ATC_V01.05 Page 257 of 469 2/10/04
Confidential / Released
<cid>.
A special form of the set command,
AT+CGQMIN= <cid> causes the minimum acceptable profile for context
number
<cid> to become undefined. In this case no check is made against the negotiated profile.
AT&F and ATZ will undefine the minimum QoS profiles of every context which is not active or not online.
Parameter Description
Parameter specifies a particular PDP context definition. The parameter is local to the TE-MT interface and is
used in other PDP context-related commands.
1...2
Precedence class
[0] network subscribed value
1 High Priority
Service commitments shall be maintained ahead of precedence classes 2 and
3
2Normal priority
Service commitments shall be maintained ahead of precedence class 3
3 Low priority
Service commitments shall be maintained
Delay class
The delay parameter defines the end-to-end transfer delay incurred in the transmission of SDUs through the
GPRS network(s).
[0] network subscribed value
1..4 SDU size: 128 octets:
SDU size: 1024 octets:
<cid>
(num)
<precedence>
(num)
<delay>
(num)
Delay Class Mean Transfer Delay 95 percentile
1 (Predictive) <0.5 <1.5
2 (Predictive) <5 <25
3 (Predictive) <50 <250
4 (Best Effort) Unspecified
Delay Class Mean Transfer Delay 95 percentile
1 (Predictive) <0.5 <1.5
2 (Predictive) <5 <25
3 (Predictive) <50 <250
4 (Best Effort) Unspecified