Siemens MC55 - Page 344

MC55 AT Command Set
12.17 AT+CSMS
s
m obil e
MC55_ATC_V01.05 Page 344 of 469 2/10/04
Confidential / Released
Mobile Terminated Messages:
0 Type not supported
1 Type supported
Mobile Originated Messages:
0 Type not supported
1 Type supported
Broadcast Type Messages:
0 Type not supported
1 Type supported
Notes
• If CSMS mode is switched from Phase 2+ to Phase 2 and one or more AT+CNMI Parameter are Phase 2+
specific a '+CMS ERROR: unknown error' will appear. It is recommended to switch the
AT+CNMI Parameters
to Phase 2 specific values before entering Phase 2.
•Phase 2+ (
<service>=1) must be set before the following features can be used:
- Configuring procedures for indicating received short messages with the
AT+CNMI parameters <mt>=2 or
<mt>=3 and <ds>=1.
- Acknowledging incoming short messages with
AT+CNMA.
- Receiving Status Reports and acknowledging them with
AT+CNMA.
<mt>
(num)
<mo>
(num)
<bm>
(num)