Siemens MC55 - Page 64

MC55 AT Command Set
3.1 AT+CMER
s
m obil e
MC55_ATC_V01.05 Page 64 of 469 2/10/04
Confidential / Released
Unsolicited Result Code
+CIEV: <indDescr>, <indValue>
A value of an indicator has changed.
Command Description
The read command returns the URC presentation mode <mode> and among others, the indicator event reporting
status
<ind>.
The write command enables and disables the presentation of "
+CIEV: <indDescr>, <indValue>" URCs.
<indDescr> refers to the name of a "+CIEV" indicator and <indValue> is the new value of this indicator. All
registered indicator events will be issued to the TE.
Parameter Description
0
(&F)
Discard "+CIEV" and "^SLCC" URCs.
1 Discard "
+CIEV" and "^SLCC" URCs when TA-TE link is reserved, e.g. in
online data mode. Otherwise they are forwarded directly to the TE.
2 Buffer "
+CIEV" and "^SLCC" URCs in the TA while TA-TE link is reserved, e.g.
in online data mode, and flush them to the TE afterwards. Otherwise they are
forwarded directly to the TE.
3Forward "
+CIEV" and "^SLCC" URCs directly to the TE. If MC55 is in online
data mode, URCs are signaled via sending BREAK (100ms) and stored in a
buffer. Once it is back in command mode e.g. after
+++ was entered, all URCs
stored in the buffer will be output.
0
(&F)
Keypad event reporting is not supported by MC55.
0
(&F)
Display event reporting is not supported by MC55.
0
(&F)
Disable indicator event reporting.
2 Enable indicator event reporting.
0
(&F)
TA buffer of URCs defined within this command is cleared when <mode> 1..3
is entered.
Name of indicator; for a list of all supported indicators please refer to
AT+CIND and AT^SIND.
Value of indicator; for a list of all values for the supported indicators please refer to
AT+CIND and AT^SIND.
<mode>
(num)
<keyp>
(num)
<disp>
(num)
<ind>
(num)
<bfr>
(num)
<indDescr>
(str)
<indValue>
(num)