MC55 AT Command Set
3.3 AT^SIND
s
m
obil
e
MC55_ATC_V01.05 Page 72 of 469 2/10/04
Confidential / Released
0 Indicator is deregistered, i.e. no such indicator event report (URC) will be
issued.
1 Indicator is registered.
• Indicator event reports are controlled via
AT+CMER.
• Indicators defined by
AT^SIND remain deregistered until explicitly enabled.
• On the other hand indicators supported by
AT+CIND are registered while
the MC55 is powered up.
2 Query the registration status and the current value of a single indicator type.
Note
• Notes regarding indicator voice message waiting:
- "vmwait1" and "vmwait2" indicate the receipt of a short message coded as Voice Message Waiting Indi-
cator, as defined by the CPHS Phase 2 standard. The service must be provisioned by the operator.
- The presentation mode of the indicators varies with the operator: If more than one message is received,
some operators only indicate the first one, others deliver the indicator each time a new message is put into
the mail-box.
- The "vmwait" indicators do not apply if a network provider signals, via standard SMS, a message in the
voice mailbox. In this case, the indicator "message" will be displayed (see
AT+CIND).
- The numbers 1 or 2 in "vmwait1/2" are related to the two lines of the Alternate Line Service (ALS), also
defined in CPHS Phase 2 standard. For further details refer to the
AT^SALS command.
<Mode>
(num)
To Next Page
Loading...
