Parameterizing the Mobile Panel
5.13 Configuring network operation
Mobile Panels 2nd Generation
Operating Instructions, 09/2018, A5E33876626-AC
137
Sm@rtServer on fail-safe Mobile Panels 2nd Generation
Note the following safety information if you want to operate the Sm@rtServer option in
combination with a fail-safe Mobile Panel 2nd Generation.
The plant operator is responsible for security
If the Sm@rtServer is activated on an HMI device locally by an operator ("local operator"),
an operator outside the system ("external operator") can monitor and operate the HMI
device via a Sm@rtServer.
Not keeping to the following warnings can result in death or serious injuries.
You should also observe the following warnings without fail.
Risk assessment of the plant
Permitted modes must be part of the risk assessment of a fail-safe automation system.
If the modes, e.g. "setup mode" and "automatic mode", are not taken into account in the
risk assessment, adequate protection against possible dangers is not guaranteed.
Death or serious bodily injury can result.
For every fail-safe automation system, the permitted modes must be part of the risk
assessment.
The responsibility for performing the risk assessment lies with the operator of the plant.
The Sm@rtServer function must be taken into account in the risk assessment of a fail-safe
automation system.
If the use of the Sm@rtServer is not taken into account in the risk assessment, adequate
protection against possible dangers is not guaranteed.
Death or serious bodily injury can result.
For every fail-safe automation system it is necessary to perform a risk assessment taking
into account the Sm@rtServer function. This also applies when the Sm@rtServer function
is used later in an existing system.
The responsibility for performing the risk assessment lies with the operator of the plant.
To Next Page
Loading...
