The test documents used for reviewing and documenting adherence to the specifications are
just as important:
● Factory Acceptance Test (FAT), also known as Installation Qualification (IQ)
● Site Acceptance Test (SAT) also known as Operational Qualification (OQ)
● Performance Qualification (PQ)
These documents are used for quality assurance purposes during a plant's entire lifecycle.
The PCS 7 compendia should be taken into account for the design guidelines and test
specifications.
4.2.2 Plant concept
Introduction
The following plant concept is used in this documentation as an example for implementing
process automation:
Preparation and administration
4.2 Preparatory planning
Compendium Part A - Configuration Guidelines (V8.2)
Configuration Manual, 08/2016, A5E38166869-AA 17
To Next Page
Loading...
